A customer is considering a Brocade VCS Fabric for their environment and the Spanning Tree
Protocol (STP) is required outside the fabric. Which feature must be disabled on the edge ports?
You need to perform packet captures on a Brocade VDX 6730-76 switch for both a packet
analyzer and an Intrusion Detection System (IDS), requiring bi-directional flows to both. The
packet analyzer is connected to port Te 26/0/15l and the IDS is connected to Te 26/0/12. The
source port for the bi-directional flow has a server connected to it on port 26/0/15. You are unable
to capture a bi-directional flow on both the packet analyzer and the IDS ports when using SPAN.
Why is this happening?
The network administrator needs to capture the frames on a Brocade VDX switch interface for
analysis using SPAN. How is this implemented?
You are adding a Brocade VDX 6720 switch to an existing Brocade VCS Fabric. You will use
interface 1/D/1 to connect to a Brocade VDX 6730 in the existing fabric.
Which configuration parameter must be present on interface 3/0/1?
Your network design calls for the management of all switches in-band.
What will allow configuration management on the Brocade VDX platform?
You have an existing Brocade VCS Fabric and are in the process of adding an additional RBridge.
The existing fabric has a zoning configuration enabled and has the default zoning mode set to no
access. When connected, the new RBridge is segmented.
Which configuration entry on the new
RBridge would cause it to segment?
You have setup the port-channel on your Brocade VDX 6730 running in standalone mode. The
other side of the port-channel is a non-Brocade networking switch that supports 802.3ad. The
configuration has been reviewed and the port-channel is configured correctly on both the
Brocade VDX and the non-Brocade switch. After performing an in-line trace, it was determined
that the Brocade VDX is not transmitting traffic. What is causing this problem?
You install a new 10 Gbps Twinax cable. The port comes online but immediately goes offline.
How would you determine the cause of this problem?