Exam information

Exam 150-810: Brocade Certified Ethernet Fabric Professional 2013

Other exams

Why is this happening?

Flow control has not been established to the port shown in the exhibit. Why is this happening?

Which two configuration changes will allow the connection to activate?

You want to connect a Brocade VDX 6730 to a Brocade DCX 8510-4 SAN fabric. When thephysical connection is made, the connection does not become active.Which two configuration changes will allow the connection to activate? (Choose two)


Which two actions would resolve this problem?

As part of your VCS fabric design, you are connecting a remote FC SAN to your VCS fabric. TheSAN is 7 km away in a nearby office. You have a connection to the FC router, but it is notfunctioning properly. Which two actions would resolve this problem? (Choose two)

which action would result in faster recovery?

You notice that several vLAG enabled devices are experiencing slow recovery time for FCoEwhen there is a failure on the vLAG. Referring to the exhibit, which action would result in fasterrecovery?

which port will be blocked by ELD?

ELD has been configured globally and enabled on edge ports. Referring to the exhibit, which portwill be blocked by ELD?

What should you do?

You are troubleshooting an OSPF problem in an existing OSPF environment through a telnetconnection. You are trying to determine the scope of the problem and use the command debugip ospf events to further troubleshoot. No output is displayed after issuing this command.What should you do?

Which two troubleshooting steps should you perform to isolate the problem?

You are not able to ping across the VCS fabric. Which two troubleshooting steps should youperform to isolate the problem? (Choose two)

Which two steps should you take to troubleshoot this problem?

You are implementing an LACP LAG between a Brocade VCS fabric and an existing IP network.The LAG has not formed. Which two steps should you take to troubleshoot this problem? (Choosetwo)

what is causing this connectivity issue?

You are connecting a server to interface te 1/2/4. The server administrator is complaining that theserver has no network connectivity. Referring to the exhibit, what is causing this connectivityissue?

which switch would be elected as the Principal RBridge?

Referring to the exhibit, which switch would be elected as the Principal RBridge?

Page 1 of 1612345...10...Last »

Recent Comments