Questions

Which command would you configure globally on a Cisco router that would allow you to view directly connected Cisco devices?

Which command would you configure globally on a Cisco router that would allow you to view directly connected Cisco devices?

A.
enable cdp

B.
cdp enable

C.
cdp run

D.
run cdp

Discussion

One Response to “Which command would you configure globally on a Cisco router that would allow you to view directly connected Cisco devices?”

  1. iCalvyn.com says:

    cdp run

    To enable Cisco Discovery Protocol (CDP), use the cdp run global configuration command. To disable CDP, use the no form of this command.

    cdp run

    no cdp run

    http://www.cisco.com/en/US/docs/ios/12_2/configfun/command/reference/frf015.html#wp1017573

Leave a Reply