Category: 310-302

Exam 310-302: Sun Certified Network Administrator for Solaris 10 OS

How can you add a static route to ClientA to make it reach ClientB?

Refer to the Exhibit.

Due to changes to the network you are managing, ClientA must access ClientB. The system HOST-GW is multi-homed and has routing and IP forwarding enabled on all of its interfaces. ClientA has a static default route configured to 192.168.100.1. ClientB has a static default route configured to ext-gw (10.1.1.1).

How can you add a static route to ClientA to make it reach ClientB?

Which entry is incorrect?

Refer to the Exhibit.

A portion of your network has three networks: NET1, NET2, and NET3.

All clients on NET2 have the default route set to 192.168.1.1.

All clients on NET3 have the default route set to 192.168.3.1.

Clients on the NET2 network are NOT able to reach any of the clients on NET3. You are given the following output of the netstat -rn command from Sys11:

# netstat -rn
Routing Table: IPv4
Destination Gateway Flags Ref Use Interface
——————- ————- ——- —– —– ———–
192.168.3.0 192.168.3.1 UG 1 0
192.168.1.0 192.168.1.1 U 1 191 hme0
192.168.2.0 192.168.30.2 UG 1 0
192.168.30.0 192.168.30.31 U 1 176 qfe0
224.0.0.0 192.168.1.1 U 1 0 hme0
127.0.0.1 127.0.0.1 UH 1 3 lo0

Which entry is incorrect?

Which command do you need to run to allow this machine to immediately begin forwarding packets between the thr

Refer to the Exhibit.

You have a system that is directly connected to three local IPv6 networks. Currently this machine can talk to other hosts on each of the three networks. However, machines on different networks cannot talk to each other, even though they all have this system configured as their default IPv6 router. The output of routeadm is shown in the exhibit.

Which command do you need to run to allow this machine to immediately begin forwarding packets between the three directly connected networks?

Which two changes could you make to optimize the Solaris IP Filter configuration without changing its function

Refer to the Exhibit.

You have taken over management of a Solaris system with the Solaris IP Filter configuration shown in the exhibit. You want to improve the performance of this system.

Which two changes could you make to optimize the Solaris IP Filter configuration without changing its functionality? (Choose two.)


Page 1 of 1712345...10...Last »